Here are some movies to guide you with your RRDE-3A and DRE.
A guidance for the setup of your RRDE-3A, also a quickly instructions for the maintenance of your system.
In addition, a useful instruction for the handling of your Disk Removable Electrode (DRE).
- RRDE-3A easy setup
- RRDE-3A disassembling/assembling for maintenance
- RRDE-3A motor rotation issue
- DRE electrode assembly methods Part1:Front Assembly
- DRE electrode assembly methods Part2:Rear Assembly
- Rotation issue
- Spin coating
RRDE-3A easy setup
Follow this movie to setup your RRDE-3A in 5 minutes.
This movie will show you the content of the system, and the setting of the gas purging and rotation, in a manual mode. For the remote mode, please follow the instruction for the manual.
RRDE-3A disassembling/assembling for maintenance
This movie will show you how to disassemble your RRDE-3A for maintenance.
By disassembling the RRDE-3A, you can Replace carbon brushes, shaft, and bearing.
RRDE-3A motor rotation issue
This movie will show you how to fix a rotation issue.
If the coupling has entred inside the aluminium frame, it may block the rotation.
If carbon brushes are broken, please change them.
Check the bearing assembly and the shaft. If they are not in good condition (corrosion, twisted...), please change them.
DRE electrode assembly methods Part1:Front Assembly
The assembly of the DRE is shown step by step in two movies. The part 1 for the front assembly and part 2 for the rear assembly.
Part 1 movie for the front assembly, it makes possible the polish of the electrode after finished the assembly.
DRE electrode assembly methods Part2:Rear Assembly
Part 2: Rear assembly, assembling procedure to avoid that the disk electrode surface can be touched.
It is required for the assembly of the surface modified disk electrode.
Spin coating using RRDE-3A rotating ring disk electrode device Ver.1.2.
- For easy confirmation, we drop a large amount of water.